The release of PCMflash version 1.3.1 brings a lot of features and improvements, and this blog post will explain exactly what they are.
Module 29:
The most significant new feature is the addition of module 29, Ford PWM, which adds support for Delphi ECUs. This module supports reading, writing, verification, and correction of checksums. The support for checking and correcting checksums was previously only available with the Delphi ECU module.
Module 43:
“JLR” is supporting the MED17.9.9 ECUs installed on Jaguar vehicles with 2L Ingenium petrol engines. It supports reading and writing calibrations, as well as verification and correction of checksums.
Module 46:
“Toyota/Lexus/Scion/Hino generation 2”, will solve the previous problem there was with reading some versions of the ECU software for 3.5l gasoline engines.
Module 51:
“China” adds support for the MED17.8.10 ECU used in Jetour vehicles with a 1.6L petrol engine (F4J16). This module supports reading, writing, as well as verification and correction of checksums.
Module 53:
“Infineon Tricore BSL” has been improved so it will now be allowed to read the password of some Suzuki, and Chery cars, as well as to support checking and correcting checksums of CPEGP / CPGPSH and MED17.0.1 ECUs.
Module 54:
“Delphi DCM3.7 / AP (SH72513/72543/72544)” now adds support for DCM3.7AP ECUs installed in Bobcat/Kioti/McCormick tractors. the module supports reading, and writing as well as verification, and correction of checksums.
Module 58:
“VAG DSG/CVT” is made for DSG DQ250C. This module now supports virtual reading and improves work with some firmware versions.
Module 71:
With “Bosch MEDC17 Bootloader”, can you now read, and write, as well as verify and correction of checksums for ME17.8.8, ME17.8.8.1, ME17U6, and MED17.8.10 ECUs.
Module 75:
“Ford Power Stroke” adds support for the DC3A hardware version of the EDC17CP05 ECU.
Module 82:
“Bosch SH725xx TCU Bootloader” adds support for the microcontroller of the SH72539 family used in the 6DCT360 Zotye robotic gearbox control unit.
Module 83:
“VAG Bosch DQ380/DQ381/DQ500/ZF 8HP” now allows for updating the ZF 8HP automatic transmission software.
Module 86:
“China Gearbox” adds support for the 7DCT330 robotic gearbox ECU installed on Geely Coolray and Emgrand vehicles, as well as 7DCT300 installed on Haval vehicles. It supports reading (when directly connected to the ECU connector), virtual reading, writing, as well as checking and correcting checksums.
Module 89:
“China MG1” has improved the work with Chery vehicles and added support for MG1US008 ECUs installed on FAW vehicles, as well as MG1UA008 ECUs installed on Geely and SWM vehicles. It supports reading, writing, checking, and correcting checksums.
